Nowadays in related industries need more aggregate and sand but rules for using natural aggregates are becoming stricter everyday.
Also,crushing kits should pay special attention to lower cost,production,higher product quality depreciate the performance and strengths and weaknesses of each mineral crushing and processing equipment allows esteemed miners to have the necessary vision in purchasing the machines they need and proceed to purchase.
Production of sufficient aggregate with higher quality and fracture percentage not only increases the life of the final product also saves cement,water,bitumen and other additives .
Rock and Rock includes a rotor with 3 output ports. In this rotor, anti-wear liners are used for coating, which collides with the aggregates inside a chamber by rotating and creating high torque(It should be noted that percentage of the same aggregates as a coating on the inner wall of the body play the role of liner and protect the body of the device This saves a lot in using of erosive parts and also achieves a breakage of 96 to 97% in the production of aggregates. These crushers can be used both in open circuits and in closed circuits so that the return material is added again as feed to the raw materials. These crushers should not be used for minimal operation because reducing the crushing performance will damage the body and increase the wear of this equipment.
The point:remember these things about rock & rock
-increasing the rotor speed results more accurate output range
– Increasing the rotor speed reduces the rotor performance
-Increasing the rotor speed causes more power consumption per ton of product
-Therefore, high rotor speed alone is not a criterion, on the other hand, low rotor speed will cause problems
-Low speed increases the amount of wear in the rotor
– Low speed causes unreasonable rotation of materials in the circuit
– Low speed will require more screen
-The following factors are very important to change the output size of a rock and rock product
– The amount of input load to the rotor feed valve
-Rotor rotation speed
-The amount of input load from the cascade part of the rotor
-Size of incoming aggregates
AMS Industrial Group hopes that this article will be useful for you, the activists in the field of crushing and processing of fruitful minerals, and pave the way for better, higher quality production and less depreciation of your equipment.